Installation instructions for roof window electrical opener
Remove the handle
Remove the handle by removing the two screws.
Prepare the pattern
Cut the pattern on the edge of the installation instructions in order to ensure the installation is accurate.
Position the paper pattern on the striking plate and use a pencil to mark where to drill holes for the brackets.
Fixing the brackets
Fix the brackets with screws. Use the marked points.
Fixing the plate
Fix the plate to the handle. Use the pre-drilled holes.
Fixing the chain holder
Fix the plate to the handle. Use the pre-drilled holes. Fix the chain holder to the fixed plate. Drive the screw into the motor chain.
Fixing the motor
Fix the motor to the installed brackets.
Open the control unit box by removing the screws.
Connecting the wires
Fix all wires according to the circuit diagram. If you only want to use the remote control, connecting to the wall switch is not necessary.
Fixing the chain
Open the chain to the maximum position by using the wall switch or remote control. Position the chain into the chain holder. Push the fixing screw into the hole. Fix the screw with the screw driver.
Job well done!
The motor is correctly fixed onto the window frame.