Installing the Roller Shutters for roof windows
Preparing for the power supply
Use the cardboard tool on top of the covering to mark the position of the slot.
Cut the aluminium at the edge.
Use a screwdriver to shape the hole (as shown in the installation instructions).
Making the cable slot watertight
Insert the cord leader into the slot.
Hammer it until it fits tightly around the hole.
Remove and dispose of the red plastic protection.
Installing the brackets holding roller shutter top case
Position the top brackets onto the covering as shown in the photo.
Mark the hole with a pen.
Pre-drill the holes for the screws (making sure you use the correct size drill).
Add butyl to the hole to make sure it is watertight.
Fix the case holder.
Repeat the entire process on the other side of the window.
Installing brackets for the lower trundle
Position the brackets for the trundle onto the side covering at the bottom sash as shown in the photo.
Mark the holes with a pen. The position is correct, when the lower hole covers the existing screw that fixes the window covering.
Remove the screw from the window covering.
Drill the extra hole.
Apply butyl to make the holes watertight.
Fix the brackets for the trundles by using the shimmed screws. Afterwards repeat the entire procedure on the other side of the window.
Installing the roller shutter top case
Place the case onto the top of the window.
Separate the supply cable.
Put the cable through the cord leader on the top covering until the plastic cover fits tightly.
Fix the plastic cover and the cable leader onto the top covering. Please use the separate screws from the cord leader bag.
Install the top case onto the brackets.
Position the lower hole on the brackets.
Secure the case and apply the safety ring.
Installing the roller shutter frame
Assemble the frame. Connect the side channels and the bottom frame.
Fix the frame parts together. Use the special screws.
Fit the frame to the trundles. Check if the trundles run correctly in the side rails on both sides.
Connect the open side rails to the top case as shown in the photo.
Fix the frame to the top case. Use the shorter screws.
Connecting the roller shutter to the control unit
Locate the cable on the roller shutter.
Install the extension connector.
Insert the cable with two cords from the control unit in the electrical kit. Match the cords and the connector by colour.
Locate the long connector on the control unit.
Remove the connector from the control unit.
Insert the correct cords to the connector (match the colours).
Secure the cords in the connector.
Connecting the sensor
Remove the back of the sensor included in the electrical kit to prepare to connect it to the control unit.
Find the three cords in the sensor cable and connect the pins as shown in the photo.
Fit the back of the sensor onto the wall in the required position.
Put the sensor cover back on.
Connect the sensor to the connector in the control unit by matching the colours and fixing the cords.
Place the connector back in the control unit.
Connecting the remote control
Put batteries into the remote control.
Tune the remote control and the sensors onto the same frequency by pushing the buttons on both the remote control and the sensor at the same time and holding them for 5 seconds.
Testing the roller shutter
You can now test the shutter. Please note that you can operate the roller shutter regardless of whether the window is open or closed.